10964

ERREKA IRIS IR02/868, IR04/868 - radio (RF) remote control, replacement

12397.jpg
12398.jpg27.jpg
Price BRUTTO:
(VAT 21%)
18.9 EUR
Part number:IRIS-7748-gate
Availability:> 10 pieces in stock
Warranty terms: Brand new, 2 years guarantee,
accepting returns within 30 days
 
Pcs

Delivery to EU: 2 to 7 days, non-EU: 2-20 days

SHIPPING COST WORLDWIDE IS 7 EUR

Replacement remote control ERREKA IRIS IR02/868, IR04/868 - 100% replacement of the original remote control.

Remote control is dedicated for ERREKA device models: DNS424 (DINGO), ER200C (ERGOS), RIS1000EC (RINO), RIS1000EIC (RINO), RIS600EC (RINO). (There may not be listed all compatible models. If you are not sure, just tell us your device model (by online chat, email), we will promptly check, verify if compatible. The verified compatibility is quaranteed by us.)

This remote control is available on branded remote control General GATE (seen on the left side). We guarantee that the remote control will perform all the functions of the original RC.

  • The RF remote control General GATE fully replaces the original remote control.
  • Only one single remote control could be used up for 4 different brands or models of different Frequencies (270-870 MHz).
  • Remote control works with both fixed and rolling codes.
  • Multifrequency auto-scan remote control.
  • Copying/cloning of the code/protocol from the original remote control.
  • Battery Panasonic CR2032 included.
  • Dimensions: 69 x 34 x 10 mm
  • If any specific colour required, state this information to the customers’ note during placing an order.

How to copy the code from the original remote control:

  1. While holding button no. 1 pushed, press four times button no. 4 on the remote control General GATE.
  2. Release both buttons. LED diode flashes shortly approx. every 2 sec.
  3. Put the original remote control (2-5 centimetres) in the front of General GATE.
  4. Push and hold button you would like to copy on the original remote control until LED diode on General GATE shines permanently (then release this button).
  5. The LED diode on General GATE flashes shortly (approx. every 2 sec.). This informs you that you need to transmit SEED code for successful duplication.
  6. Create an electrical bridge between pins 1 and 5 of the 5-way connector on the original remote control. The remote control will shine permanently. Put the original remote control close to General GATE again.
  7. Take out the connecting part, the diode on the original remote control will switch off.
  8. Put the original remote control close to General GATE again and press the same button as in point no. 4. of this manual.
  9. Once the LED diode (on General GATE) is flashing quickly, push required button on General GATE. LED diode will light up and then it will switch off.

How to REGISTER the new remote control into the original receiving unit:

It is not necessary to register the remote control to Receiving Unit, it works immediately after copying the code from the original remote control.

One single RF General GATE remote control for all: gate, garage door, venetian blind and indoor lightning. Other 3 buttons of the remote control could be programmed for other devices which require RF (radio) remote control. So it can control up to 4 different devices / receivers. This remote control could be used and programmed for any brand (with both fixed and rolling code). General GATE is THE ONLY RF remote control that you can program with codes of different door/gate manufacturers/frequencies into one General GATE. Supported frequency 280-870 MHz.



For


 

.
Copyright © 2021 REMOTE CONTROL WORLD.