Spare remote controller WISNIOWSKI PULSAR 2CH IO 868,95 MHz - 100% replacement for original remote controller.

It is fully compatible with the following WISNIOWSKI models: AXOVIA IO, ELIXO IO, METRO IO, METRO SMART IO, ROLLIXO IO (There may not be listed all compatible models. If you are not sure, just tell us your device model (by online chat, email), we will promptly check, verify if compatible with your device. The verified compatibility is guaranteed by us.)

• It is a fully-fledged spare remote controller, shown on the left (It is not „universal“).
• The remote controller is guaranteed for 2 years.

You will receive a remote controller ready to use. The only thing you have to do is register the remote controller to control unit of engine/drive.

We supply the remote control shown on the left.

Process of registering remote controller to main unit:

1. Remove the cover of the WISNIOWSKI drive unit - the display will show the message "C1".
2. Press and hold the PROG button for 2 seconds - the display will show the message "F0".
3. Press and hold the button on the new remote control. You must hold the button for approximately 25 seconds! The display should then show the message "ADD" and the WISNIOWSKI unit will switch back to operational mode, i.e., to "C1".
4. Test the remote control.