Replacement radio (RF) remote control fully compatible with the type PROTECO TX 4334.

Savršena 1:1 kopija, dizajnirana i proizvedena od strane naše tvrtke – sadrži sve funkcije originalnog daljinskog upravljača za sljedeće modele marke PROTECO: PŘIJÍMAČ RX433 3, PŘIJÍMAČ RX4331 L, PŘIJÍMAČ RX4331,, Q22, Q25, Q36A (S), Q37, Q54, Q60A (S), Q80A (S), Q90A (S). (There may not be listed all compatible models. If you are not sure, just tell us your device model (by online chat, email), we will promptly check, verify if compatible with your device. The verified compatibility is guaranteed by us.)

This remote control is available on branded remote control General GATE (shown on the left). We guarantee that the remote control will perform all the functions of the original RC.

• The RF remote control General GATE fully replaces the original remote control.
• Only one single remote control could be used up for 4 different brands or models of different Frequencies (270-870 MHz).
• Remote control works with both fixed and rolling codes.
• Multifrequency auto-scan remote control.
• Copying/cloning of the code/protocol from the original remote control.
• Battery Panasonic CR2032 included.
• Dimensions: 69 x 34 x 10 mm
• If any specific colour required, state this information to the customers’ note during placing an order.

Kopiranje koda s originalnog daljinskog upravljača:

1. Pritisnite i držite tipku 1 na General GATE daljinskom upravljaču, a zatim pritisnite tipku 2 četiri puta.
2. Otpustite obje tipke. Plava indikatorska LED na General GATE daljinskom upravljaču će kratko trepćati svake dvije sekunde.
3. Stavite originalni daljinski upravljač koji želite duplicirati ispred ili pored General GATE daljinskog upravljača.
4. Na originalnom daljinskom upravljaču pritisnite i držite tipku koju želite duplicirati. Držite tipku na originalnom daljinskom upravljaču pritisnutu dok crveni indikatorski LED na General GATE daljinskom upravljaču brzo trepće.
5. U tom trenutku pritisnite tipku na kojoj želite pohraniti kod. Crveni LED na daljinskom upravljaču će kratko svijetliti, a zatim se ugasiti. Ovo potvrđuje ispravnu pohranu koda na odabranoj tipki.
6. Kopiranje je uspješno završeno. Daljinski upravljač je spreman za ODITELJNU upotrebu.

How to REGISTER the new remote control into the original main unit:

It is not necessary to register the remote control to Receiving Unit, it works immediately after copying the code from the original remote control.

One single RF General GATE remote control for all: gate, garage door, venetian blind and indoor lightning. Other 3 buttons of the remote control could be programmed for other devices which require RF (radio) remote control. So it can control up to 4 different devices / receivers. This remote control could be used and programmed for any brand (with both fixed and rolling code). General GATE is THE ONLY RF remote control that you can program with codes of different door/gate manufacturers/frequencies into one General GATE. Supported frequency 280-870 MHz.