General OTIO transmiter 4 - compatible remote control for gate
Replacement radio (RF) remote control fully compatible with the type OTIO transmiter 4.
Attention please: there is another 2nd model - NOT compatible (only with RF RECEIVER)! Choose remote control according to your former one appearance.
The remote control has been specially developed for the following OTIO models: ARM 300, ARM 300 P, ARM 400, ARM SOLAR A SLIDE 350, ARM300, ARM300P, ARM400, OTIO 771014, OTIO 771015, OTIO 771016. (There may not be listed all compatible models. If you are not sure, just tell us your device model (by online chat, email), we will promptly check, verify if compatible with your device. The verified compatibility is guaranteed by us.)
This remote control is available on branded remote control General GATE (shown on the left). We guarantee that the remote control will perform all the functions of the original RC.
- The RF remote control General GATE fully replaces the original remote control.
- Only one single remote control could be used up for 4 different brands or models of different Frequencies (270-870 MHz).
- Remote control works with both fixed and rolling codes.
- Multifrequency auto-scan remote control.
- Copying/cloning of the code/protocol from the original remote control.
- Battery Panasonic CR2032 included.
- Dimensions: 69 x 34 x 10 mm
- If any specific colour required, state this information to the customers’ note during placing an order.
The remote control supplied is already pre-programmed on buttons 1 and 2. You only need to register the remote control to your original receiving unit memory
Copying Code from the Original Remote Control:
- Press and hold button 1 on the General GATE remote control, then press button 2 four times.
- Release both buttons. The blue indicator LED on the General GATE remote control will briefly flash every two seconds.
- Place the original remote control that you want to duplicate in front of or next to the General GATE remote control.
- On the original remote control, press and hold the button you want to duplicate. Keep holding the button on the original remote control until the blue LED on the General GATE remote control lights up. Then release the button on the original remote.
- After a short while, the blue indicator LED on the General GATE will blink twice every two seconds. This alert informs the user that sending an additional signal is required for successful duplication.
- Prepare the original remote control for sending the "SEED" code. Simultaneously press and hold buttons 1 and 2 on the original remote control. Once the LED starts blinking on the original, release the buttons (NOTE: THESE BUTTONS ARE PLACED DIAGONALLY).
- While the LED on the original remote control is blinking, place it back next to the General GATE remote control. Press the same button on the original remote control as in step 4 and hold it down until the LED on the General GATE remote control changes its blinking rate (it will blink faster) and the indicator LED turns red.
- At this point, press the button where you want to save the code. The red LED on the remote control will briefly light up and then turn off, confirming the correct code storage on the selected button.
- After learning the signal, the remote control needs to be paired with the drive unit.
How to REGISTER the new remote control into the original main unit:
- Remove the cover of the receiving unit.
- Find “RF” button.
- Push this button and hold it for 5 sec. Red diode should turn on.
- Push programmed button on General GATE. Red diode starts to flash.
- Push programmed button on General GATE once again for confirmation.
One single RF General GATE remote control for all: gate, garage door, venetian blind and indoor lightning. Other 3 buttons of the remote control could be programmed for other devices which require RF (radio) remote control. So it can control up to 4 different devices / receivers. This remote control could be used and programmed for any brand (with both fixed and rolling code). General GATE is THE ONLY RF remote control that you can program with codes of different door/gate manufacturers/frequencies into one General GATE. Supported frequency 280-870 MHz.
Featured Products
General BAR silver - simple remote control
General ZOOMY Remote control with big buttons for seniors, kids
Categories
- Remote controls for TELEVISION
- Remote controls SAT, DVBT, DVBC
- Remote controls DVD, DVD/VCR, BD
- Remote controls TV BOX, PVR, VCR
- Remote controls for HOME THEATRE
- Remote controls AUDIO, CD, AMP
- Remote controls CAR RADIO/DVD
- Remote controls GATES and DOORS
- Remote controls for PROJECTOR
- Remotes for AIR CONDITION, FAN
- Remote controls BLINDS, SHUTTERS
- Remotes for WIN, iOS, ANDROID
- Remote controls CARAVAN MOVER
- Remote controls CUSTOM GENERAL
- Remote controls VARIOUS, SPECIAL
- Remote controls CLASSIC
- Signal EXTENDERS
- RC CASES, SPARE PARTS
- REMOTE CONTROL REPAIRS
- VARIOUS SERVICES AND EXTRAS
Need help?
Choose the brand and model of your device, we will help you find a fitting remote control!
Customer reviews
Thank you very, very much. I am really happy, because I was searching...
Read more...
Received configured remote and it works perfectly. Thanks
Read more...
But it's not. Got my remote for a 2001 AV receiver Onkyo RC-443S...
Read more...
Got the order within 10 days, what is exceptional good. According to...
Read more...
The remote is working really good, even from a distance, even when I...
Read more...
Les compré una réplica de un denon871, pero cuando lo recibí, no...
Read more...
I must admit that I did not believe it very much...but it was really...
Read more...
Hi I ordered an original Panasonic EUR7722XC0 but was shipped a...
Read more...
Ordered a remote (axd 7305)for my old Pioneer home cinema system....
Read more...
J'ai acheté plusieurs télécommandes compatibles pour mon...
Read more...