CHAMBERLINE replacement remote control

CHAMBERLINE replacement remote control CHAMBERLINE replacement remote control
(VAT 21%)
18.0 EUR
Part number:CHAMBERLINE-generalGATE
Availability:7 Pieces in stock
Warranty terms: Brand new, 2 years guarantee,
accepting returns within 30 days
Manufactured by: CHAMBERLINE

Delivery to EU: 2 to 7 days, non-EU: 2-20 days



Replacement the original remote control CHAMBERLINE. Functionality of the remote control is the same as the original. 

For models: 94335F, 94333E, 94330E, 84335E, LM60K, LM60R, LM50K, LM600, LM800A, 4410EGB, MOTORLIFT 2000, MOTORLIFT 5000, JM60, 5580, LM1000A, LM3800A, GAROG DKN, MOTORLIFT 500

The replacement remote control General GATE shown on the left side!.

  • The RF remote control General GATE fully replaces the original remote control.
  • Only one single remote control could be used up for 4 different brands or models of different frequencies.
  • Remote control works with both fixed and rolling codes.
  • Multifrequency auto-scan remote control.
  • Copying/cloning of the code/protocol from the original remote control.
  • Battery Panasonic CR2032 included.
  • Dimensions 69 x 39 x 10 mm
  • If any specific colour required, state this information to the customers’ note during placing an order.
  • The price is for 1 piece of the replacement remote control General GATE.

RF remote control General GATE.

How to copy the code from the original remote control:

  1. While holding button no. 1 pushed, press four times button no. 4 on the remote control General GATE.
  2. Release both buttons. LED diode flashes shortly approx. every 2 sec.
  3. Put the original remote control (2-3 centimetres) in the front of General GATE.
  4. Push and hold button you would like to copy on the original remote control. LED diode will flash quickly as a confirmation of successful copying of the code.
  5. While LED diode flashes quickly, push required button on General GATE. LED diode will light up and then it will switch off.
  6. Copy was successfully made. Now you can use the remote control.

​​How to log the new remote control into the original receiving unit:

  1. Open the RF Receiver cover.
  2. Press and release the colored (somewhat orange, somewhere purple) learning button. The learning display lights without interruption for 30 seconds.
  3. Press and hold the button on the remote control to control the door for 30 seconds.
  4. Release the button as soon as the drive light flashes. Code is taught. If no lighting is installed, two click tones are heard.

One single RF General GATE remote control for all: gate, garage door, venetian blind and indoor lightning. Other 3 buttons of the remote control could be programmed for other devices which require RF remote control. This remote control could be used and programmed for any brand (with both fixed and rolling code). General GATE is THE ONLY RF remote control which is suitable for more RF devices.

This product was added to our catalog on Monday 25 June, 2018.



Copyright © 2020 REMOTE CONTROL WORLD.