Brand Original remote control ENDURO EM303A, EM305, EM405.

This remote control has been replaced by fully compatible original genuine EM313A, EM302, EM303, EM303A remote control (shown on the left).

________________________________________________________________________________________________________________________________________________

Pairing the Remote Control with the Hypercam Excellent automatic control box:

1. Turn on the control box and the remote control.
2. Press the RESET button on the control box; all 3 LED lights on the control box will start flashing slowly.
3. Simultaneously press the FORWARD and REVERSE buttons on the remote control and hold them for about 3 seconds (see picture below). You should then hear a short beep confirming successful synchronization. After successful synchronization, the green LED light on the remote control and the green LED light on the control box will continuously illuminate.

NOTE: If no signal is received from the control box, you will hear regular beeping from the remote control buzzer.

This is an ORIGINAL remote control, therefore it does not require any pairing, setup, or codes. Just insert the batteries and it works with all the models mentioned above.