TAU 250 SLIM - radio (RF) remote control, replacement

Replacement remote control TAU 250 SLIM - 100% replacement of the original remote control.

Remote control is dedicated for TAU device models: 250-BUG2, 250-K-SIM, 250-SLIM, 250-TX2, 250BUG4, 250T-4, 250T-4C, 250TX4. (There may not be listed all compatible models. If you are not sure, just tell us your device model (by online chat, email), we will promptly check, verify if compatible. The verified compatibility is quaranteed by us.)

This remote control is available on branded remote control General GATE (seen on the left side). We guarantee that the remote control will perform all the functions of the original RC.

• The RF remote control General GATE fully replaces the original remote control.
• Only one single remote control could be used up for 4 different brands or models of different Frequencies (270-870 MHz).
• Remote control works with both fixed and rolling codes.
• Multifrequency auto-scan remote control.
• Copying/cloning of the code/protocol from the original remote control.
• Battery Panasonic CR2032 included.
• Dimensions: 69 x 34 x 10 mm
• If any specific colour required, state this information to the customers’ note during placing an order.

How to copy the code from the original remote control:

1. While holding button no. 1 pushed, press four times button no. 4 on the remote control General GATE.
2. Release both buttons. LED diode flashes shortly approx. every 2 sec.
3. Put the original remote control (2-3 centimetres) in the front of General GATE.
4. Push and hold button you would like to copy on the original remote control until LED diode flashes quickly (before quick flashing the diode shines permanently).
5. While LED diode flashes quickly, push and hold required button on General GATE until LED diode goes off as a confirmation of successful copying of the code.
6. Copy was successfully made and it is ready to be used.

How to REGISTER the new remote control into the original receiving unit:

It is not necessary to register the remote control to Receiving Unit, it works immediately after copying the code from the original remote control.

One single RF General GATE remote control for all: gate, garage door, venetian blind and indoor lightning. Other 3 buttons of the remote control could be programmed for other devices which require RF (radio) remote control. So it can control up to 4 different devices / receivers. This remote control could be used and programmed for any brand (with both fixed and rolling code). General GATE is THE ONLY RF remote control that you can program with codes of different door/gate manufacturers/frequencies into one General GATE. Supported frequency 280-870 MHz.