Replacement radio (RF) remote control fully compatible with the type ERREKA IRIS IR2/IR4 433,92 MHz.
The remote control has been specially developed for the following ERREKA models: DNS424 (DINGO), ER200C (ERGOS), RIS1000EC (RINO), RIS1000EIC (RINO), RIS600EC (RINO). (There may not be listed all compatible models. If you are not sure, just tell us your device model (by online chat, email), we will promptly check, verify if compatible with your device. The verified compatibility is guaranteed by us.)
This remote control is available on branded remote control General GATE (shown on the left). We guarantee that the remote control will perform all the functions of the original RC.
- The RF remote control General GATE fully replaces the original remote control.
- Only one single remote control could be used up for 4 different brands or models of different Frequencies (270-870 MHz).
- Remote control works with both fixed and rolling codes.
- Multifrequency auto-scan remote control.
- Copying/cloning of the code/protocol from the original remote control.
- Battery Panasonic CR2032 included.
- Dimensions: 69 x 34 x 10 mm
- If any specific colour required, state this information to the customers’ note during placing an order.
Copying Code from the Original Remote Control:
- Press and hold button 1 on the General GATE remote control, then press button 2 four times.
- Release both buttons. The blue indicator LED on the General GATE remote control will briefly flash every two seconds.
- Place the original remote control that you want to duplicate in front of or next to the General GATE remote control.
- On the original remote control, press and hold the button you want to duplicate. Keep holding the button on the original remote control until the blue LED on the General GATE remote control lights up. Then release the button on the original remote.
- After a short while, the blue indicator LED on the General GATE will blink twice every two seconds. This alert informs the user that sending an additional signal is required for successful duplication.
- Prepare the original remote control for sending the "SEED" code. Create an electrical bridge between pins 1 and 5 on the 5-way connector of the original remote control. The remote control will remain lit continuously. Place it back next to the General GATE remote control.
- Once the LED on the GENERAL GATE remote control starts blinking rapidly, press the button on which you want to store the just-copied code. The LED will light up and then turn off after a moment.
- Remove the connecting piece, and the original remote control will turn off.
- Now, the remote control needs to be paired with the drive unit.
How to REGISTER the new remote control into the original main unit:
It is not necessary to register the remote control to Receiving Unit, it works immediately after copying the code from the original remote control.
One single RF General GATE remote control for all: gate, garage door, venetian blind and indoor lightning. Other 3 buttons of the remote control could be programmed for other devices which require RF (radio) remote control. So it can control up to 4 different devices / receivers. This remote control could be used and programmed for any brand (with both fixed and rolling code). General GATE is THE ONLY RF remote control that you can program with codes of different door/gate manufacturers/frequencies into one General GATE. Supported frequency 280-870 MHz.
Featured Products
General BAR silver - simple remote control
General ZOOMY Remote control with big buttons for seniors, kids
Share your device's brand and model, and we'll handle the rest. Our experts will handle the request and your tailored recommendations will be on their way via email.