Replacement radio (RF) remote control fully compatible with the type DEA MIO TD.

The remote control has been specially developed for the following DEA models: GHOST 200, LIVI 1501, LIVI 3, LIVI 401, LIVI 500, LIVI 801, LOOK, MAC, MIO TD2, MIO TD4, OLI 600, SPAZIO, WING 302. (There may not be listed all compatible models. If you are not sure, just tell us your device model (by online chat, email), we will promptly check, verify if compatible with your device. The verified compatibility is guaranteed by us.)

This remote control is available on branded remote control General GATE (shown on the left). We guarantee that the remote control will perform all the functions of the original RC.

• The RF remote control General GATE fully replaces the original remote control.
• Only one single remote control could be used up for 4 different brands or models of different Frequencies (270-870 MHz).
• Remote control works with both fixed and rolling codes.
• Multifrequency auto-scan remote control.
• Copying/cloning of the code/protocol from the original remote control.
• Battery Panasonic CR2032 included.
• Dimensions: 69 x 34 x 10 mm
• If any specific colour required, state this information to the customers’ note during placing an order.

The remote control supplied is already pre-programmed on buttons 1 and 2. You only need to register the remote control to your original receiving unit memory

Copying Code from the Original Remote Control:

1. Press and hold button 1 on the General GATE remote control, and then press button 2 four times.
2. Release both buttons. The blue indicator LED on the General GATE remote control will briefly flash every two seconds.
3. Place the original remote control that you want to duplicate in front of or next to the General GATE remote control.
4. On the original remote control, press and hold the button you want to duplicate. Keep holding the button on the original remote control until the red indicator LED on the General GATE remote control blinks rapidly (before the red LED blinks, the blue LED may light up for a moment).
5. At this point, press the button where you want to save the code. The red LED on the remote control will briefly light up and then turn off, confirming the correct code storage on the selected button.
6. The copy has been successfully created. The remote control needs to be paired with the drive unit (refer to the drive unit manual).

How to REGISTER the new remote control into the original main unit:

1. Remove the cover of the receiving unit.
2. Use the +/- buttons to switch to P005 in the receiving unit. Confirm with the OK button, LEAr will appear on the display and the LED flashes. Now PJ is ready to register a new remote control.
3. Press the button on the remote control you want to register. Hold 1 second.
4. The blinking LED goes out in 2 seconds and is stored in the memory. The number assigned to the remote control number (for example r001).
5. The receiving unit automatically returns to the registration mode, and in the same way gradually add another remote control.
6. Wait 10 seconds before all newly registered remote control is stored. Now try the new remote control.

One single RF General GATE remote control for all: gate, garage door, venetian blind and indoor lightning. Other 3 buttons of the remote control could be programmed for other devices which require RF (radio) remote control. So it can control up to 4 different devices / receivers. This remote control could be used and programmed for any brand (with both fixed and rolling code). General GATE is THE ONLY RF remote control that you can program with codes of different door/gate manufacturers/frequencies into one General GATE. Supported frequency 280-870 MHz.